Graphite ingot molds and rods in casting

· 1 min read · Tools

Graphite is used in jewelry for ingot molds, stirring rods for molten metal and soldering blocks, because it resists heat and molten metal does not stick to it.

Graphite ingot molds and a rod

Graphite is a carbon material very resistant to heat to which molten metal does not stick. That is why it is used in ingot molds, stirring rods and bench blocks.

Graphite ingot molds #

Bar-shaped molds into which molten metal is poured to make ingots. The metal releases easily and the mold is reusable.

Graphite rods #

Used to stir molten metal in the crucible and mix the alloy without contaminating it.

Graphite blocks #

They serve as a surface for soldering or melting small quantities, and help protect the metal with a reducing atmosphere.

Care #

Graphite is brittle and oxidizes at very high temperatures, so it wears away. Store it dry and clean off flux residue.

Why graphite #

It withstands very high temperatures, does not stick to molten metal and cleans easily. That is why it is used for ingot molds, stirring rods and support blocks.

Frequently asked questions #

Does it wear out? Yes, with use it erodes and carbonizes; replace it when it has cracks.

Does it stain the metal? It should not: if it leaves residue, clean the mold and burn off the excess.

See also #

This entry was drafted with the help of AI and is pending review by the author.