# Laser and spot welding

> Laser and spot welding join metal with very localized heat, without flux or torch; ideal for repairs next to stones and enamel.

- Source: https://www.711grados.com/en/laser-and-spot-welding/
- Language: en
- Note: This entry was drafted with the help of AI and is pending review by the author.
- Published: 2026-07-07
- Updated: 2026-07-07
- Translation (es): https://www.711grados.com/es/soldadura-laser-y-por-puntos/
- Author: Sandra Sánchez
- Site: 711 Grados (https://www.711grados.com/)

---

Laser welding (and spot arc welding) melts metal at a tiny point without heating the rest of the piece. It is a staple tool of repair workshops.

![Steps of the technique: Clean, Hold, Set, Weld, Add wire, Finish](https://www.711grados.com/media/diagrams/soldadura-laser-steps.en.svg "Summary of the steps")

## How it works

A concentrated laser pulse melts the metal at the joint, sometimes with a filler wire of the same metal, under an inert gas atmosphere (argon) that protects the area.

## Advantages

No flux is needed and in many repairs the stones need not be removed, heat is minimal and the joints are clean and almost invisible. It is especially useful with platinum.

## Limits

The equipment is expensive and the weld is very local, so it does not replace torch soldering in every case.

## Uses

Repairing chains and prongs, adjusting sizes, closing links and rebuilding edges.

## Safety

Work with specific eye protection and a closed chamber or filters.

## Step by step

1. **Clean.** Remove grease, oxide and dirt.
2. **Hold.** Position the piece and protect the stones.
3. **Set.** Adjust energy, duration and spot diameter.
4. **Weld.** Fire pulses on the joint.
5. **Add wire.** If needed, add metal with a fine wire.
6. **Finish.** Polish the area.

## Tools and materials

- Laser welding machine
- Filler wire of the same metal
- Specific protective glasses
- Tweezers and supports

## Common mistakes

- Excessive energy: it pierces the metal.
- Welding without proper eye protection.
- Dirty surfaces: the joint comes out weak.
- Overheating next to sensitive stones.

## See also

- [Soldering for jewelry](https://www.711grados.com/en/jewelry-soldering/)
- [Prong retipping](https://www.711grados.com/en/prong-retipping/)
- [Handmade chains](https://www.711grados.com/en/handmade-chains/)