# Jeweler's files: shapes and cuts

> Jeweler's files (flat, half-round, round, needle) and their cut numbering; how to choose and clean them.

- Source: https://www.711grados.com/en/jewelers-files/
- Language: en
- Note: This entry was drafted with the help of AI and is pending review by the author.
- Published: 2026-09-06
- Updated: 2026-09-09
- Translation (es): https://www.711grados.com/es/limas-de-joyero/
- Author: Sandra Sánchez
- Site: 711 Grados (https://www.711grados.com/)

---

Files shape metal. They are distinguished by their profile and by the tooth size (the cut).

![Six jeweler's file types with their cross-section: flat, half-round, round, triangular, square and knife](https://www.711grados.com/media/diagrams/file-types.en.svg "File types: profile and use of each")

![File cut scale from 00 (very coarse) to 6 (very fine) with the use of each](https://www.711grados.com/media/diagrams/file-cuts.en.svg "Cut numbering: the higher the number, the finer the tooth")

## Profiles

Flat, half-round, round, triangular, square and knife. Needle files are small and delicate, for details.

## Cut

Indicated by a number: lower ones are coarser (for roughing) and higher ones fine (for finishing).

## Care

Clean with a wire brush, do not hit them and store them apart.

## Use

See [filing and sanding](https://www.711grados.com/en/filing-and-sanding/).

## How to choose the file for each job

1. **Start with a cut 0 or 2** to remove excess metal and give the general shape.
2. **Move to a cut 4** to erase the marks of the previous file.
3. **Finish with a cut 6** (or with sandpaper) before polishing.

For a flat face, use the flat file; for the inside of a band, the half-round; for cleaning a hole, the round. A fine file never fixes a job started with a badly directed coarse one: always change from coarse to fine.

## Hand files and needle files

**Hand files** are 15 to 20 cm long and are used on larger pieces. **Needle files** are shorter and finer (14 to 18 cm), with or without a handle, and are used for details, settings, piercing and corners. Both follow the same cut numbering.

## How it is used

Hold the piece resting on the bench pin and file **forward**, with pressure only on the push stroke. On the return, lift the file so as not to dull it. Keep the file flat on the surface to avoid rounding the edges.

## Cleaning and maintenance

Soft metal (silver, gold, copper) clogs between the teeth and scratches the piece. Clean the file with a wire brush, brushing in the direction of the teeth, or rub it with chalk before use. Store files apart so they do not knock together and avoid humidity.

## Common mistakes

- Filing back and forth with the file tilted: it rounds the edges.
- Using a coarse file to finish: it leaves deep scratches.
- Hitting the file or using it as a lever: it breaks.
- Filing near a stone without protecting it.

## See also

- [Filing and sanding: shaping and smoothing](https://www.711grados.com/en/filing-and-sanding/)
- [Jeweler's bench and bench pin](https://www.711grados.com/en/jewelers-bench/)
- [Jeweler's saw and saw blades](https://www.711grados.com/en/jewelers-saw/)